Instructions:
1. Charge the batteries fully before use. (About 7 hours charging)
2. Connect the battery to the power cable located in the front pocket of the jacket (USB socket). Be careful with
do not pull strongly on the connector.
3. Press the jacket control button. The diode lights up and you can choose the heating level from among the 3 available by pressing the button.
• Blue LED = heating at minimum level
• White LED = heating at intermediate level
• Red LED = heating at maximum level
4. To switch off, press the button for 1 second. The button backlight turns off.
Temperature Chart:(Tested in a room at 23℃)
Mode Temperature Autonomy:
Red LED 47-49℃ 3-4h
White LED 42-45℃ 4-5h
Blue LED 39-40℃ 8-9h
Technical data :
Charging time: 5h
Battery voltage: 5V
Battery capacity depending on the model: 10000 or 20000 mAh
Usable Voltage: 5V
Battery life: 500+ charges
CE certification
Battery charger:
Charging conditions: direct current & constant voltage (CC/CV)
Charging temperature: 0℃ to 45℃
Input: AC/100-230V 40-60Hz
Output: DC/4.2V 500mA*2
Maintenance:
• We recommend washing the jackets by hand or in the washing machine at 30°C on a delicate programme.
• Do not turn on the heater when charging to protect the circuits.
• The battery can be charged and discharged approximately 500 cycles. In case of prolonged non-use, it is recommended to charge it
every 3 months to conserve battery life.
• Do not approach near the fire
• Do not use if the electrical components (battery/circuit/heating system) are damaged.
Warning, this product contains a battery, at the end of its life please dispose of it in an appropriate collection place, consult the site: www.ecosystemes.fr